3 {{ upvoteCount | shortNum }}
3 {{ upvoteCount | shortNum }}

Peerfly Data Not Showing SUBID 3

by digitalguru
2 replies
Hi,

I have run into another problem. This is the following link and how I have set it up. The code below is the part after the link.

&subid=###KEYWORD###&subid2=###AFFID###&subid3=### RID###&email



I have tried it both with the "&email=" and without it

The data from Peerfly is showing all the results except the subid3. This is crucial so I can block the traffic source. Do you know why this is happening. I doubled checked it and the code is correct but still get no data in that table column.

I was hoping someone will be able to help me out and what is going on.
#data #peerfly #showing #subid
  • Profile picture of the author SticKer
    I think I see the problem. Could be the space before RID that is not passing the subid 3 data.

    Also, I'm not sure if the &email is required to be added. I just use the code without it and get all the 3 subids in my reports.
    {{ DiscussionBoard.errors[6817872].message }}
    • Profile picture of the author LukePeerFly
      Originally Posted by SticKer View Post

      I think I see the problem. Could be the space before RID that is not passing the subid 3 data.

      Also, I'm not sure if the &email is required to be added. I just use the code without it and get all the 3 subids in my reports.
      Correct, the space will cause the RID not to show up in your 3rd SubID slot. You can remove the &email from your link if you are not pre-popping (which you can't if you are direct linking on 7Search).

      I have a complete guide to setting up your 7Search campaign at:
      Setting up a 7Search Campaign

      Let me know if you have any other questions
      Signature

      ^ My Blog

      Are you an affiliate that runs PPV advertising? You need my PPV target scraper!
      Have a Facebook Page? FPTraffic, manages over 1,000,000,000 (BILLION) Likes! Check it out :)
      {{ DiscussionBoard.errors[6819231].message }}

Trending Topics